Smoke Leak Detector

The SDT208 and the upgraded SDT206 have the same number of functions, but the SDT208 still performs better because it has higher output pressure and output flow than the upgraded SDT206.

SDT208 also supports 12V and 24V car batteries as power supplies. The following is the detailed introduction of SDT208.

Product use

AUTOOL SDT208

Professional Auto Pipe Leak Detection

AUTOOL SDT208 is a professional auto pipe leak detect tool. It will help us position leakage on any pipe system quickly and exactly, such as EVAP system, Intake system, exhaust system, and so on.

Operation method

Step-by-step setup

Operation Method

  1. Add test oil: After assembling the smoke leak detector accessories, inject about 30ML of test oil each time you use it. The test oil injected each time should not exceed the MAX scale, and it is recommended to work continuously for no more than 15 minutes.
  2. Open the engine bay: Open the engine cover and remove the air filter. Some models need to remove the airflow sensor.
  3. Seal the intake hose: Place the standard conical adapter into the engine air intake hose port to plug the pipe, then press hard until the air intake hose is sealed.
  4. Connect the battery: Connect the power cord to the car battery, with the red alligator pliers to the positive battery terminal and the black alligator pliers to the negative battery terminal.
  5. Turn on power: After the battery is connected correctly, turn on the main power switch. The power indicator lights up, indicating that the smoke generator power supply is normal.
  6. Select the proper mode: In large car or pipeline complex conditions, enable “high-pressure mode.” First press the “high-pressure mode” switch, and then press the “detection start” switch. The air pump will start working, and only after the air pump starts can the “smoke start” switch start working. Under the condition of trolley or pressure-sensitive original, enable “low-pressure mode.” First press the “low-pressure mode” switch, then press the “detect start” switch. The air pump will start to work, and only after the air pump starts can the “smoke start” switch start to work.
  7. Start smoke output: Press the “smoke start” switch, and the smoke begins to produce. After the smoke start, if the system detects that the instrument is not enough smoke oil or the continuous working time is too long, resulting in the system overheating, the “overheat protection indicator” light will be on until the temperature drops to the normal range and the instrument resumes work.
  8. Check for leaks: Depending on the model, about 1 minute after the smoke start, the engine pipeline will be filled with smoke. Start to check the system leakage fault points.
  9. Finish and store: Check the end, then remove the power cord and put away the accessories for the next time to take. The main body of the air inlet adapter is made of rubber; please avoid contact with gasoline and other corrosive liquids.
Care notes

Maintenance

Maintenance

  • With a long time high temperature, the smoke and oil will oxidize and deteriorate. It will affect the service life of the smoke-generated part, so please change smoke and oil regularly.
  • When the smoke output has water drops, please replace it with fresh oil.
  • Please fill fresh oil with the equipped oil bottle.
Video reference

AUTOOL SDT208

Product Video

This is a video of our AUTOOL SDT208. For more great videos, please follow our YouTube channel.

Related Products

Rendered through WooCommerce product shortcode so the cards inherit the global product-card structure and Blocksy/WooCommerce styles.

Laisser un commentaire

Votre adresse e-mail ne sera pas publiée. Les champs obligatoires sont indiqués avec *